Network Setting Stored In Imaging Unit; Connection Setup For A Multiple Number Of Sensor Units - Canon CXDI-40G COMPACT Service Manual

9.3.3 Network Setting Stored in Imaging Unit

The factory default setting is shown in the table below.
There is no need to change the settings when a single sensor unit is to be connected to the
control PC.
If a multiple number (2 or more) of sensor units are to be connected to the control PC, the IP
address setting for one or more of the sensor units must be changed. (* Refer to "9.3.4.

Connection setup for a multiple number of sensor units.")

Item to be set
Imaging unit IP address
Subnet mask
Gateway address
Host IP address
Port number for command
Port number for data
To change the settings, follow the instructions in "7. Imaging Unit IP Address setting" found in
the "Tool Software Operation Manual for Ethernet."
2. Installation
Factory default value
192.168.100.11
255.255.255.0
000.000.000.000
192.168.100.10
12121
12122
- 43 -