Attaching The Sensor Cable And Ready Lamp Cable - Canon CXDI-40G COMPACT Service Manual

4.3 Attaching the Sensor Cable and Ready Lamp Cable

The sensor cable and ready lamp cable can be attached to the imaging unit either before or after
the imaging unit is installed in the Bucky unit, stand or table. Check the structure of the Bucky
unit, stand or table obtained from the distributor, and attach the sensor cable and ready lamp cable
using the easiest procedure. This manual describes the procedure for attaching the cables before
installing the imaging unit.
Notes
* If the imaging unit is installed to the Bucky unit, stand or table by a single operator
when the sensor cable and ready lamp cable are already connected, there is a risk of the
cables getting pinched or bent. Therefore, be sure to install the imaging unit to the
Bucky unit using two or more operators.
1) Remove the two screws on the connector cover, and remove the connector cover.
2) Remove the two screws on the cable mounting plate, and attach the cable mounting plate from
the imaging unit. Next, remove the two screws on the conductive holder , and remove the
conductive holder from the cable mounting plate.
Cable mounting plate
2. Installation
Connector cover
Conductive holder
- 15 -
Screws (2)