Canon CXDI-40G COMPACT Service Manual page 93

Parameter
-B border_density
Border density (Dx100)
(BLACK/WHITE/D x
100)
-G empty_image_density
Empty image density
(BLACK/WHITE/D x
100)
-T trim
Trimming (NO/YES)
-P polarity
Polarity
(NORMAL/REVERSE)
-r pixel_pitch
Transfer pixel pitch for
designating the request
image size (Pixel Pitch in
um)
-N annoFmt
Annotation position
(1/2/3)
-n annotation
Annotation (character
string)
2 . I n s t a l
2 . I n s t a
Meaning
* This parameter is used in the
DICOM Basic Film Box (2010,
0100).
* This parameter determines the
area density around the image
on the film.
* This parameter is used in the
DICOM Basic Film Box (2010,
0110).
This parameter designates the
density of the empty image
area during multi-formatting.
* This parameter is used in the
DICOM Basic Film Box (2010,
0140).
* This parameter adds lines
around the image.
* The CXDI is normally adjusted
so that the trimming does not
appear.
* This parameter is used in the
DICOM Basic Image Box
(2020, 0020).
* Reverse image density
* This parameter is used in the
DICOM Basic Image Box
(2020, 0010).
* Position of the image on film
* The cumulative value for the
horizontal size of the image
(raw) at the designated pixel
pitch is used for the request
image size.
* The CXDI automatically uses
131072 internally for
operation.
* The above value can be
overwritten by designating a
specific value.
* This parameter is used in the
DICOM Basic Annotation Box
(2030, 0010).
* This parameter designates the
position of the character string
to be annotated.
* This parameter is used in the
DICOM Basic Annotation Box
(2030, 0020).
* This parameter designates the
character string to be
annotated.
- 73 -
l a t i o n
l l a t i o n
If this parameter is not designated,
it is not transferred over DICOM. In
this case, the printer default values are
used.
If this parameter is not designated,
it is not transferred over DICOM. In
this case, the printer default values are
used.
If this parameter is not designated,
it is not transferred over DICOM. In
this case, the printer default values are
used.
* For example, the default value for
this parameter in Agfa printers is
YES. Therefore, the NO option
needs to be specifically designated if
it is desired.
If this parameter is not designated,
it is not transferred over DICOM. In
this case, the printer default values are
used.
If this parameter is not designated,
it is not transferred over DICOM. In
this case, the type of image that is
printed depends on the settings at the
printer side.
* If using annotation, always be sure to
transfer the annotation position.
* If this parameter is not designated, it
is not transferred over DICOM. In
this case, the printer default values
are used.
* Also, in this case, the type of image
that is printed depends on the
settings at the printer side.
Description