2.4 Operations from the Exposure Ready Condition
2.4.1 Operations from the Exposure Ready Condition
You can perform the following operations.
To continue exposure with the same patient data
Touch and select a sensor unit and an exposure mode.
To output images already taken and continue the exposure
Touch [SEND].
However, note that [SEND] is displayed only when SEND AFTER EXPOSURE (→
Setup Guide) is set to [SEND].
Depending on the installation setup by a service engineer, the IMAGE DESTINATION
window may open automatically when you touch [SEND]. (→ page 27)
The image output indicator
To output all the images which have not been output yet and end the exposure of
the current patient
Touch [END STUDY].
Depending on the installation setup by a service engineer, the IMAGE DESTINATION
window may open automatically when you touch [END STUDY]. (→ page 27)
The image output indicator
Retaking an Image
Touch the preview image button and touch [RETAKE] on the preview image screen. (→
page 41)
blinks green during image output.
blinks green during image output.
– 25 –
2. Taking an Image
Continued on the following page >>