Remarks; Shipment - Pylontech PowerCube-M1-C Operation Manual

Storage
For long-term storage, if stored for a long time (more than 3 months), the battery cells should be
stored in the temperature range for 5~45℃, relative humidity <65% and contains no corrosive gas
environment.
The battery should shelfed in 5~45℃, dry, clean and well ventilated environment. Before storage
the battery should be charged to 50~55% SoC;
It is recommended to discharge and charge the battery every 3 months, and the longest
discharge and charge interval shall not exceed 6 months.
Caution: If not follow the above instructions for long term store the battery, The cycle
life will have relative heavily reduction.
Si vous ne suivez pas les instructions ci-dessus pour stocker la batterie à long terme,
cela réduira son cycle de vie.
Capacity expansion
A new battery module can be add onto an existing system at any time. Please make sure the
existing system is being fully charged before add on a new module. In a serial connection
system, the new module, even has a higher SOH, will follow the system worst SOH condition
module to perform.
For single battery cell will as 55%SOC or according to customer requirement before shipment. The
remaining capacity of battery cell, after shipment and before charge, is determined by the
storage time and condition.
1. The battery modules meet the UN38.3 certificate standard.
2. In particular, special rules for the carriage of goods on the road and the current dangerous
goods law, specifically ADR (European Convention on the International Carriage of Dangerous
Goods by Road), as amended, must be observed.
5.

Remarks

6.

Shipment

57