Installing The Buckets Or Microplate Carriers; Using The Tie-Down Screw And Torque Bar To Tighten The Rotor - Beckman Coulter JS-5.2 Instructions For Use Manual

JS-5.2 and JS-4.0 Swinging-Bucket Rotors
Preparation and Use
Figure 4 Using the Tie-Down Screw and Torque Bar to Tighten the Rotor onto the Drive Hub (Older Rotors)
1. Torque Bar (878439)

Installing the Buckets or Microplate Carriers

1
Lubricate the contact area between the buckets or carriers and the pivot pins on the rotor yoke
as described under Inspection.
2
Place buckets or carriers over the pivot pins on the rotor yoke.
a. Fill all four positions with a bucket or carrier.
3
Make sure that the buckets or carriers are properly seated by gently swinging them on the
pivot pins.
1-14
1
2. Rotor Tie-Down Screw (339031)
2
J6-TB-006AP