Error Messages; Table 3.4 Error Code Classifications; Table 3.5 Ldx-32420 Series Error Codes - ILX Lightwave LDX-32420 User Manual

3
C H A P T E R

Error Messages

In the event of a hardware error condition, error messages will be displayed on the
display. In most cases, the error message will appear for three seconds. In some
cases the error code display will remain until the user changes display modes. In
the case of multiple error messages, the display may sequentially show each
message for three seconds. In addition to the hardware errors, remote command
errors may be read via the ERR? query. Table 3.4 lists the numerical error ranges
by function. Table 3.5 contains all of the error messages that may be generated.
Not all of these messages may appear on the front panel displays. Some refer to
remote operation activities only.
In remote operation, the errors can be read by issuing the ERR? query. When this
is done, all of the error messages that are resident in the error queue are returned
(up to 10 may be stored). Reading the error queue via GPIB or USB clears the
error queue.

Table 3.4 Error Code Classifications

Error Code Range
E-001 to E-099
E-100 to E-199
E-200 to E-299
E-300 to E-399
E-500 to E-599

Table 3.5 LDX-32420 Series Error Codes

Error Code
E-001
E-103
E-104
E-105
E-106
E-123
E-124
E-126
E-201
E-202
E-203
38
 LDX-32420
R E M O T E O P E R A T I O N
Error Messages
Explanation
Memory allocation failure
<DEFINITE LENGTH ARBITRARY BLOCK PROGRAM DATA> length too long
<NON-DECIMAL NUMERIC PROGRAM DATA> type not defined
<DECIMAL PROGRAM DATA> exponent not valid
<DECIMAL PROGRAM DATA> digit expected
Command not found
<program mnemonic> Lookup, failed because query/command type match failed
Too few or too many program data elements
<PROGRAM DATA> value out of range
<PROGRAM DATA> will not convert to valid type
Security violation, command is not available without clearance
Area of Operation
Internal Program Errors
Parser Errors
Execution Control Errors
Communication Errors
LASER Control Errors