ILX Lightwave LDX-32420 User Manual page 71

4
C H A P T E R
LASer:ENABle:EVEnt <flags>
LASer:ENABle:EVEnt?
Parameters
Notes
Examples
54
 LDX-32420
C O M M A N D R E F E R E N C E
LDX-32420 Device-Dependent Command Reference
The LASer:ENABle:EVEnt command sets the status event enable register of the LASER
operations. These events are summarized in bit 2 of the status byte register.
The LASer:ENABle:EVEnt? query returns the value of the status event enable register of
the LASER operation.
An <nrf value> whose sum represents the bits that are enabled:
1 LASER Current Limit
2 LASER Voltage Limit
4 N/A
8 Power limit
16 Interlock changed state
32 N/A
64 Compliance Voltage Limit
128 Open circuit
The enable registers normally retain their values at power-up (as they were at power-
down) unless the power-on status clear flag is set true (for more information see the
*PSC definition, in the GPIB-IEEE488 specification).
"LAS:ENAB:EVENT 136" - action: enables the LASER status event register so that the
Open circuit and Power limit events will be reported (in summarized form) to the status
byte (bit 2).
"LAS:ENAB:EVE?" - response: 1040, means that the Output on/off state change and
Interlock changed LASER events will be reported (in summarized form) to the status byte
register (bit 2).
256 Output is shorted
512 Output changed to be in/out of tolerance
1024 Output on/off state changed
2048 New measurements taken
4096 N/A
8192 N/A
16384 N/A
32768 N/A
F P
RONT ANEL
R
EMOTE