ILX Lightwave LDX-32420 User Manual page 73

4
C H A P T E R
LASer:EVEnt?
Notes
Examples
56
 LDX-32420
C O M M A N D R E F E R E N C E
LDX-32420 Device-Dependent Command Reference
The LASer:EVEnt? query returns the value of the status event register of the LASER
operations.
- where the response is the sum of the following:
1 LASER Current Limit
2 LASER Voltage Limit
4 N/A
8 Power limit
16 Interlock disabled
32 N/A
64 Compliance Voltage Limit
128 Open circuit
The LASER conditions that are reported in the status byte can be set by using the
LASer:ENABle:EVEnt command.
The LASER event status is only cleared when the event status is read or by the *CLS
command while the condition status is constantly changing.
"LAS:EVE?" - response: 513, means that the LASER output tolerance changed and
current limit events have occurred since the last LASer:EVEnt? query.
"Radix Hex; Laser:Event?" - response: #H88, means that the LASER Power limit and
Open circuit events have occurred since the last LASer:EVEnt? query.
256 Output is shorted
512 Output changed to be in/out of tolerance
1024 Output on/off state changed
2048 Measurement ready
4096 N/A
8192 N/A
16384 N/A
32768 N/A
F P
RONT ANEL
R
EMOTE