ILX Lightwave LDX-32420 User Manual page 26

Interlocks
Interlock 1
Interlock 2
General
Remote Interface
Power Requirements
Maximum Current Draw
Size (H x W x D)
Weight
Operating Temperature
Storage Temperature
Humidity
Regulatory Compliance
Connectors
Notes
1. All values relate to a one-hour warm-up period.
2. Over any one-hour period, half-scale output.
3. Measured electrically, with a 0.5 load evaluating AC coupled rms value over a 1 MHz bandwidth.
4. Maximum output current transient resulting from normal operations (e.g. power on-off, current on-off), as well as accidental
5. Maximum output current transient resulting from a 1000V power-line transient spike per IEC 1004-4 and 1004-5.
6. Maximum monitor photodiode current drift over any 30-minute period. Assumes zero drift in photodiode responsivity.
7. 5V peak to peak modulation at mid-scale output. Higher bandwidth is possible with smaller magnitude modulation signal.
8. From start of output current change to trigger pulse.
9. Measured current through GPIB or USB command; instrument front panel displays setpoint current.
10.The responsivity value is user-defined and is used to calculate the optical power.
01_10
GPIB
USB
Laser Output
Modulation Input
Trigger Out
Interlock 1
Interlock 2
Ground
situations (e.g. power line plug removal).
I N T R O D U C T I O N A N D S P E C I F I C A T I O N S
Normally open, close to enable output
Normally high, TTL input; TTL low to disable current
source output
IEEE488
2.0
100-120 VAC + 10%
220-240 VAC + 10%
100-120 VAC: 1.5A
220-240 VAC: 0.7A
4" x 8.5" x 13.4"; 102 mm x 216 mm x 340 mm
12.2 lbs (5.5 kg)
0°C – 40°C
-40°C – 70°C
<80% non-condensing
CE certified
EN 61326-1:2006 Basic Requirements; Immunity
EN 55011:2007 Radiated and Conducted Emissions
EN 61010-1 Safety Requirements
EN 60950 Low Voltage Directive
D-sub combination 9W4
BNC, front panel
BNC, rear panel
Terminal block, rear panel
BNC, rear panel
Banana jack
C H A P T E R
Specifications
LDX-32420
1
9
