ILX Lightwave LDX-32420 User Manual page 60

Name
LAS:LIM:V
LAS:LIM:V?
LAS:MDI
LAS:MDI?
LAS:MDP
LAS:MDP?
LAS:MODE?
LAS:MODE:IHBW
LAS:MODE:ILBW
LAS:MODE:MDP
LAS:OUT
LAS:OUT?
LAS:RAN
LAS:RAN?
LAS:SET:LDI?
LAS:SET:MDI?
LAS:SET:MDP?
LAS:STEP
LAS:STEP?
LAS:TOL
LAS:TOL?
MES
MES?
RAD
RAD?
TERM
TERM?
TIME?
TIMER?
01_10
C O M M A N D R E F E R E N C E
Parameters Function
1 Used to set the LASER compliance voltage limit value
NONE Used to return the LASER compliance voltage limit
value
1 Used to set the constant optical power setpoint, if
photodiode responsivity is 0
NONE Used to return the monitor photodiode current
measured value
1 Used to set the constant optical power setpoint
NONE Returns the actual monitor photodiode power value
NONE Returns the mode, I (current), IHBW (high bandwidth),
or P (optical power)
NONE Sets the mode to constant current, high bandwidth
NONE Sets the mode to constant current, low bandwidth
NONE Sets the mode to constant optical power mode
1 Used to enable/disable the current source output
NONE Returns the current source output status
1 Sets the laser current output range
NONE Returns the laser current output range
NONE Returns the laser constant I (current) setpoint
NONE Returns the laser constant optical power setpoint
NONE Returns the constant P (optical power) setpoint
1 Used to set the LASER setpoint step value
NONE Returns the LASER setpoint step value
2 Used to set the LASER setpoint tolerance value and
time period value
NONE Used to return the LASER setpoint tolerance value and
time period value
1 Used to enter a string message of up to 16 bits
NONE Returns a previously stored ASCII message
1 Sets the radix type for numerical data; decimal, binary,
octal or hexadecimal
NONE Used to return the radix type for numerical data
1 Used to add a carriage return to the device terminator
NONE Returns the status of the TERM command
NONE Returns the elapsed time since the instrument was last
powered up
NONE Returns the elapsed time since the timer was last reset
4
C H A P T E R
43
LDX-32420
