6�22�- Rs-485 Communications (Models Cvm-E3-Mini-Xxx) - Circutor CVM-E3-MINI Instruction Manual

 Configuration values
To validate the value, press the
If the value entered by the user is out of the range of programming values, the programmed value will
be deleted and the system will restore it to the last saved value.
Press key
6�22�- RS-485 COMMUNICATIONS (Models CVM-E3-MINI-xxx)
The RS-485 communications protocol is selected on this screen.
Press the
screen.
Press key
 Configuration values
To validate the value, press the
Press key
Note: The device will restart after exiting the setup menu if the RS-485 communications parameters
have been modified.
If the Modbus protocol has been selected, the next setup screen will be shown in section
MODBUS PROTOCOL: BAUD RATE".
78
Table 51: Configuration values: Backlight
Minimum value
Maximum value
to access the next programming step.
key for 3 seconds to enter the edit mode. The prog icon will flash on the left of the
to browse the two options.
Table 52: Configuration values: RS-485 communications�
Possible values
to access the next programming step.
Backlight
1 second.
999 seconds.
key for 3 seconds; the prog icon will stop flashing.
RS-485 communications
Modbus
nodb
BACnet.
bacn
key for 3 seconds; the prog icon will stop flashing.
CVM-E3-MINI
"6.22.1.
Instruction Manual