Table of Contents
Advertisement
Take all necessary safety precautions
!
when lifting the unit up to the roof.
1 . Loosen foot nuts . Rotate feet into mounting position
(they should look like illustration at right) . Re-tighten
foot nuts .
2 . If the fasteners you have chosen require pilot holes, place
the unit in its location and use the foot holes to mark the
pilot hole locations . Drill pilot holes .
In the event your fasteners do not align with roof beams, it is highly recommended you
TIP
drill extra holes in the mounting feet for additional mounting strength .
3 . Apply roof-compatible sealant to roof around entire area where fasteners will penetrate the roof .
4 . Mount the unit using foot mounting holes and any additional mounting holes you drilled .
5 . Seal all fastener heads and foot perimeter with roof-compatible sealant .
Depending on your roof, you may wish to use fasteners in combination with the sealant.
!
The installer is responsible for determining the best fasteners, and for waterproofing all holes
and sealing all fastener heads.
The stow plate mounts 16" in
!
front of the base mount body.
1 . Apply roof-compatible sealant
around perimeter of stow plate .
Make an "X" with sealant in the
middle .
2. Press stow plate firmly into place.
MOUNT THE UNIT
MOUNT THE STOW PLATE
KC1397
KC1397
!
Roof-compatible sealant.
Stow
Stow
Plate
Plate
16"
KC1424
KC1424
SEALANT
SEALANT
KC1403
KC1403
Page 9
Advertisement
Table of Contents
