Page 1
KOP4800 Owner’s Manual ® DIRECTV For use with satellite programming The KING One Pro works with DIRECTV, DISH , and Bell TV. This manual is for ® ™ DIRECTV subscribers. Manuals for DISH and Bell subscribers are available at kingconnect.com/support.
The satellite TV market is expanding and changing. The information in this manual was accurate at the time of printing. If your KING One Pro Satellite Antenna does not operate as outlined in this manual, please call KING at (952) 345-8147 or visit ®...
7. Do not remove the cover of the KING One Pro without authorization. Doing so will void the limited warranty. 8. Do not stack the KING One Pro on top of or below other electronic devices as this can cause heat build-up or block the satellite signal from reaching the KING One Pro.
CONNECT ANTENNA OBSERVE ALL PRECAUTIONS WHEN MAKING CONNECTIONS. Page 4...
Page 7
CHOOSE CONNECTION DIAGRAM BASED ON YOUR RECEIVER TYPE: RECEIVER CONNECTION DIAGRAM NOTES Requires DSWM30 Kit H/HR25 or higher Page 7 (sold separately) Other receivers Page 6 Make all connections and make sure your TV and receiver are turned on. During power up, the power inserter LED will pulsate orange for 10 seconds and pattern repeats...
Page 8
DIRECTV CONNECTIONS HAND-TIGHTEN COAX. OVER-TIGHTENING CAN DAMAGE CONNECTIONS. POWER INSERTER FOR INDOOR USE ONLY. Second receiver must be the same as main receiver (SWM vs. non-SWM). If your main receiver has a second “satellite in” port and built in DVR, you can connect watching.
Page 9
HR20 or later DVRs. It is not compatible with D12 receivers. POWER INSERTER FOR INDOOR USE ONLY. KING Antenna, KING Power Inserter (with power supply), 50’ coax and short coax included. All other items sold separately. Page 7...
CONFIGURE RECEIVER Make sure your TV is on the correct input from your receiver. If your receiver screen does not appear on your TV, check TV input by pressing Source/Input button on your TV or TV’s remote. • Switch Type: Multi-switch •...
Go to kingconnect.com/support. Go to the Owner’s Manual section and choose from the following: KING One Pro DISH Wally Receivers Owner’s Manual KING One Pro DISH ViP Receivers Owner’s Manual KING One Pro DISH Legacy Receivers Owner’s Manual KING One Pro Bell Owner’s Manual...
Page 13
2. Press and release button to choose MODE 5: alarm enabled (or MODE 1 if you previously enabled the alarm but now want to disable it). 3. When desired mode is displayed, press and hold button for about 3 seconds until the LED Go to the next page to start a scan.
SCAN FOR SATELLITES pattern repeats... WHILE SCANNING, DO NOT BLOCK THE ANTENNA UNIT’S LINE-OF-SIGHT TO THE SATELLITES IN THE SOUTHERN SKY AT ANY TIME! IF YOU MOVE THE ANTENNA ANY TIME DURING OR AFTER THE SCAN, YOU WILL HAVE TO REPEAT THE SCAN. When scan is complete and satellites are found, the LED will turn steady green.
Picture will return as conditions improve. The KING One Pro will not receive channels broadcast from DIRECTV’s Ka band satellites at 99° and 103°. When using page 7 connection diagram, you will not receive programming from the 119 satellite.
Connect a known good coax directly from the antenna unit to the power inserter and see if the problem goes away. If it does, the vehicle’s wiring/coax is at fault. KING is not responsible for faulty vehicle wiring/coax.
Allows you to position your KING One Pro almost anywhere for best line-of- sight to satellite. Keeps The KING One Pro is not compatible with away from moisture. the MB100 Mounting Bracket. Use of the MB100 will void warranty. KING Antenna not included.
• Customer is not the original owner. In no event shall KING be liable for any indirect, incidental, or consequential damages from the sale or use of the product. This disclaimer applies both during and after the term of this warranty. KING disclaims liability for any implied warranties, including implied warranties of “merchantability” and or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.