Attach Dish And Arm To Base Mount - KING PHOENIX KPD1000 Owner's Manual

1 . Feed coax (inside the split loom) thru the hole in the dish, from back to front .
2 . Attach the dish to the mounting brackets on the base mount using the top two holes and supplied
washers and screws (1/4"-20 x 3/4" Phillips) . Finger tighten only.
3 . Attach the LNB arm to the dish using the supplied washers and screws (1/4"-20 x 3/4" Phillips) .
Finger tighten only.
TIP
When properly oriented, the LNB arm should rotate upward towards the dish, not downward .
4 . When all six screws are properly inserted and LNB arm rotates upward (not downward) tighten
all six screws (#3 Phillips screwdriver) .
When properly installed, When properly installed,
arm rotates up arm rotates up
Page 4

ATTACH DISH AND ARM TO BASE MOUNT

KC1400 KC1400
1
Attach dish to base mount Attach dish to base mount
Attach LNB arm to dish Attach LNB arm to dish
2
(2) 1/4" Washers (2) 1/4" Washers
(2) 1/4-20 x 3/4" Screws (2) 1/4-20 x 3/4" Screws
(4) 1/4" Washers (4) 1/4" Washers
(4) 1/4-20 x 3/4" Screws (4) 1/4-20 x 3/4" Screws
3