Page 1
KOP4800 Owner’s Manual This manual contains detailed information on your KING One Pro. To start using your KING One Pro right away, see the Quick Reference Guide. ® DISH with Receivers: ® 211z • ViP211k • ViP211 • 411 IMPORTANT!
IMPORTANT! The satellite TV market is expanding and changing. The information in this manual was accurate at the time of printing. If your KING One Pro Satellite Antenna does not operate as outlined in this manual, please call KING at (952) 345-8147 or visit our website at kingconnect.com. KING is not responsible for changes outside ®...
7. Do not remove the cover of the KING One Pro without authorization. Doing so will void the limited warranty. 8. Do not stack the KING One Pro on top of or below other electronic devices as this can cause heat build-up or block the satellite signal from reaching the KING One Pro.
The KING One Pro requires an unobstructed view of the southern sky for the best signal reception. Be sure to place the KING One Pro in a location free from obstructions such as people, trees, buildings, vehicles, etc. This will allow for the strongest signal and will help prevent any interruption to your programming.
SETUP CONTENTS APPLY RUBBER FEET TO ANTENNA UNIT IMPORTANT! Do not apply rubber feet if roof-mounting the antenna unit. See the Installation Guide included in the box. Page 4...
CONNECTIONS Connect components in following order. A Connect coax cables. B Plug in power inserter. C Plug in receiver(s). Power inserter is for indoor use only. Place the power inserter in an accessible location. Do not over-tighten the coax connections. Do not put sharp bends or kinks in the cables.
ANTENNA CONFIGURATION DISH with Wally receivers and the ViP models listed in the gray box below use mode 1. The KING IF YOUR ANTENNA IS NEW, SKIP THIS STEP AND GO TO PAGE 8. MODE SERVICE SATELLITES DIRECTV 101, 119...
Page 9
IF YOUR ANTENNA IS NEW, SKIP THIS STEP AND GO TO PAGE 8. Go to next page to start a scan. Page 7...
OPERATION NEW AND UNACTIVATED WALLY RECEIVER IF YOUR RECEIVER IS NEW AND UNACTIVATED, START HERE. Otherwise go to STANDARD OPERATION on page 12. WHILE IN USE, DO NOT BLOCK THE ANTENNA UNIT’S LINE OF SIGHT TO THE SATELLITES IN THE SOUTHERN SKY AT ANY TIME! IMPORTANT! If you move the antenna unit any time during or after the scan, you...
Page 11
The Portable Antenna Setup screen will display. 2. Use the arrow buttons on your remote to highlight the letter group that includes the Press SELECT. 3. Highlight the state you are currently in from the state menu. Press SELECT. 4. Verify “Scan” is highlighted. Press SELECT.
Page 12
The receiver will download software. This step may take 20-25 minutes. 5. The receiver will reset and the Mobile Antenna Setup Screen will appear. Repeat steps 2-4 to start a second scan. The unit will scan a second time. Page 10...
Page 13
When the scan is complete, the Acquiring Signal message will display. Acquiring the signal may take up to 5 minutes to complete. 6. After your receiver has acquired the signal, it is ready to be activated. To activate service call 1-800-963-DISH (3474). 1-800-963-DISH (3474) After your receiver is activated, the electronic program guide will download.
STANDARD OPERATION IF YOUR RECEIVER IS NEW AND UNACTIVATED, MAKE SURE TO DO THE FIRST-TIME SETUP PROCEDURE ON PAGES 8-11 FIRST. WHILE IN USE, DO NOT BLOCK THE ANTENNA UNIT’S LINE OF SIGHT TO THE SATELLITES IN THE SOUTHERN SKY AT ANY TIME! IMPORTANT! If you move the antenna unit any time during or after the scan, you...
Page 15
1. Use the arrow buttons on your remote to highlight the letter group that includes the Press SELECT on your remote. 2. Highlight the state you are currently in from the state menu. Press SELECT. 3. Verify “Scan” is highlighted. Press SELECT.
Page 16
4. When the scan is complete, the Acquiring Signal message will display. Acquiring the signal may take up to 5 minutes to complete. 5. After your receiver has acquired the signal, the electronic program guide will download. This may take up to 10 minutes to complete (potentially longer if an external hard drive is connected).
Page 17
This page intentionally left blank. Page 15...
SECOND RECEIVER OPERATION Antenna locked on INITIAL SETUP FOR SECOND RECEIVER receiver connected! 1. With the antenna locked on the satellite and the second receiver connected to the antenna unit’s AUX port coax, use your DISH remote control and press MENU, 6, 1, 1 to display the Receiver sold separately.
Page 19
DOWNLOADING PROGRAMMING TO THE SECOND RECEIVER After completing the steps on the previous page, reset the second receiver by pressing the POWER button on the front panel for 10 seconds. The TV picture will go away and should reappear within two minutes. The receiver will then download the program guide to show only the channels available on the current satellite as determined by the channel selected on the main receiver.
Connect a known good coax directly from the antenna unit to the power inserter and see if the problem goes away. If it does, the vehicle’s wiring/coax is at fault. KING is not responsible for faulty vehicle wiring/coax.
Page 21
ViP211z, 211k, 211, 411 RECEIVERS Symptom/Message Possible Cause Troubleshooting Receiver is stuck on “SYS- Access card is not fully seated in Fully insert access card in receiver slot. On a TEM INFO” screen. receiver slot. ViP211z, this is located behind the front panel access door on left side of receiver.
Page 22
Symptom/Message Possible Cause Troubleshooting My remote is not working. Your batteries may need to be re- 1) Check to make sure the batteries are properly placed. inserted in your remote. If the SAT button on top of the remote does not light up when you Your remote is not currently paired press it, replace the batteries.
Page 23
Symptom/Message Possible Cause Troubleshooting Over-the-Air Antenna Chan- The quality of reception and number 1) Check that the wiring between your DISH re- nels Missing - Error 739 of channels available depends on, among other things, the over-the-air ured properly. antenna’s placement and your loca- 2) Unplug the power cord of your receiver for 10 tion.
Page 24
Symptom/Message Possible Cause Troubleshooting Guide Information Not Avail- Your receiver was not powered off at 1) Unplug the power cord of your receiver for 10 able. night to receive the nightly electronic seconds and plug it back in. It may take up to program guide updates.
KING One Pro almost anywhere for best line of sight to satellite. Keeps an- The KING One Pro is not compatible with tenna off the ground the MB100 Mounting Bracket. away from moisture. Use of the MB100 will void warranty.
This warranty does not cover installation and external wiring, or remanufactured units. This warranty does not cover damage caused by the use of an accessory other than a KING accessory designed for the product. This warranty is not transferable from the original owner.
FCC GUIDELINES This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.