KING PHOENIX KPD1000 Owner's Manual page 15

This installation does not represent the Genie 3 that has a built-in power inserter .
110 VAC 110 VAC
12 VDC 12 VDC
CONTROL CABLE CONNECTION CONTROL CABLE CONNECTION
KC1390 KC1390
110 VAC 110 VAC
21 volt power inserter used .
Do not use a 29 volt power inserter
with the KING Phoenix .
DIRECTV SWM
To REC To REC To LNB To LNB
The SWM LNB has 8 channels available .
Each DVR takes 2 channels (one coax) .
A non-DVR uses one channel (one coax) .
You may use any combination of receivers
until you use up all 8 channels .
Example: An HR34 uses 5 channels leaving
3 channels available .
Double check all electrical and
coax connections BEFORE
connecting satellite receiver and
applying power.
The control cable has 12
wires that control motors and
provide information and sensor
!
feedback. If the control cable is
mis-wired it can cause damage
to the GPS and sensors, which
may result in component failure.
Most problems are the result
of incorrect connections or
configurations.
2, 4 and 8 port splitters are available .
A 4 port splitter is shown .
Receiver 1 Receiver 1
Receiver 2 Receiver 2
Receiver 3 Receiver 3
Receiver 4 Receiver 4
Page 15