Page 1
KOP4800 Owner’s Manual This manual contains detailed information on your KING One Pro. To start using your KING One Pro right away, see the Quick Reference Guide. DISH & Wally Receivers ® ® IMPORTANT! The KING One Pro works with DIRECTV , DISH, and Bell TV.
IMPORTANT! The satellite TV market is expanding and changing. The information in this manual was accurate at the time of printing. If your KING One Pro Satellite Antenna does not operate as outlined in this manual, please call KING at (952) 345-8147 or visit our website at kingconnect.com. KING is not responsible for changes outside ®...
KING One Pro . 6 . Use caution when carrying the KING One Pro . Always carry the KING One Pro by the handle . 7 . Do not remove the cover of the KING One Pro without authorization . Doing so will void the limited warranty .
ABOUT SIGNAL LOSS OBSTRUCTIONS The KING One Pro requires an unobstructed view of the southern sky for the best signal reception . Be sure to place the KING One Pro in a location free from obstructions such as people, trees, buildings, vehicles, etc .
SETUP CONTENTS Power Inserter You will also need (sold separately): Antenna Unit with Power Supply DISH Programming Subscription Cable(s) DISH Wally KC1210 Receiver (3) Rubber Feet Quick Installation Short Registration Reference Guide 50’ RG-6 Coax Cable Card Guide Coax Cable APPLY RUBBER FEET TO ANTENNA UNIT IMPORTANT! Do not apply rubber feet if roof-mounting the antenna unit.
Power Supply MAIN Button Receivers sold separately 110 AC SAT IN To TV MAIN Receiver 50’ Coax Short KING Power Coax Inserter 110 AC SAT IN Optional AUX To TV Coax sold separately Receiver KC1187 After connecting and plugging in all components, wait for the power inserter LED to turn steady green.
ANTENNA CONFIGURATION DISH with Wally receivers and the ViP models listed below (in the gray box) use mode 1 . The KING One Pro comes factory preset for mode 1. If your antenna is new, you will not need to configure it.
Page 9
IF YOUR ANTENNA IS NEW, SKIP THIS STEP AND GO TO PAGE 8. Make sure the LED is steady green GREEN To enter Configuration Mode, press and hold (~3 sec) the power inserter button until one of the KC1218 options below appears Press and release as needed to choose Mode1 MODE 1 (DISH)
OPERATION NEW AND UNACTIVATED WALLY RECEIVER IF YOUR RECEIVER IS NEW AND UNACTIVATED, START HERE. Otherwise go to STANDARD OPERATION on page 14. SATELLITES IN WHILE IN USE, DO NOT BLOCK THE ANTENNA SOUTHERN SKY UNIT’S LINE OF SIGHT TO THE SATELLITES IN THE SOUTHERN SKY AT ANY TIME! OBSTRUCTIONS Place on a reasonably level surface...
Page 11
Receiver ID XXXXXXXXXX-XX Install • Pair Remote Control Smart Card ID XXXXXXXXXX-XX 2 . Follow the on-screen instructions Pair Your DISH Remote Control Pair Remote Control to pair your remote control . Test Installation Press the SAT button to pair your remote control to your receiver. Your timers and other settings will automatically be restored from your remote.
Page 12
Receiver ID XXXXXXXXXX-XX Install • Test Installation Smart Card ID XXXXXXXXXX-XX 6 . Use the arrow buttons on your Mobile Antenna Setup Pair Remote Control remote to highlight the state menu . Test Installation Press Select on your remote to open Please ensure your antenna is placed on a stable surface with a clear view of the southern sky.
Page 13
Receiver ID XXXXXXXXXX-XX Install • Test Installation Smart Card ID XXXXXXXXXX-XX Mobile Antenna Setup Pair Remote Control Test Installation Please ensure your antenna is placed on a stable surface with a clear view of the southern sky. If applicable, point the handle towards the north. Activate Receiver Once you have completed the selections below, please select Scan.
Page 14
Call 1-800-333-DISH (3474) Receiver ID XXXXXXXXXX-XX Install • Test Installation for assistance. Smart Card ID XXXXXXXXXX-XX After calling to activate your receiver, Downloading Wally software. Pair Remote Control a software download will begin . Test Installation Please do not disturb or unplug your DISH receiver during the download.
Page 15
Software Version U418 Receiver ID XXXXXXXXXX-XX Install • Summary Call 1-800-333-DISH (3474) for assistance. Smart Card ID XXXXXXXXXX-XX Internet Connectivity Use your internet connection to access free and paid Get Connected Internet: Not Connected on-demand titles, get proactive customer support, and more. TV Settings Set Resolution Resolution:...
NOTE: This manual shows graphics for a DISH Wally receiver . If you have a ViP model receiver, you can access the KING One with ViP Receiver Owner’s Manual by going to kingconnect.com/support . Click on “Owners Manu- als” and choose the manual for KING One with ViP receiver .
Page 17
2 . After the Wally starts up, the Mobile Antenna Setup screen will appear . NOTE FOR STEP 3: The mode menu may not be present on all receivers. Reception from the 129 may be difficult in this area. The 110, 119, 129 trio will Choose the 61.5, 110, 119 trio.
Page 18
4 . Use the arrow buttons on your remote to highlight the state menu . Press Select on your remote to open the state menu . Use the arrow buttons on your remote to highlight the state you are currently in . Press Select on your remote .
Page 19
OPERATING NOTES: If you move the KING One Pro while in use, or get a screen indicating complete signal loss, you will have to perform a new scan to restore programming by going to the Mobile Antenna Setup screen as follows: Press the HOME button to return to the home page .
SECOND RECEIVER OPERATION IMPORTANT! If your second receiver is new and unactivated, you must first connect it to the MAIN port and do an initial setup as described in the New and Unactivated Receiver Section starting on page 8. INITIAL SETUP FOR SECOND RECEIVER 1 .
KING One Pro almost anywhere for best line of sight to satellite . Keeps an- The KING One Pro is not compatible with tenna off the ground the MB100 Mounting Bracket . away from moisture . Use of the MB100 will void warranty .
. Connect a known good coax directly from the antenna unit to the power inserter and see if the problem goes away . If it does, the vehicle’s wiring/coax is at fault . KING is not responsible for faulty vehicle wiring/coax .
Then call DISH at 1-800-333-DISH to have your locals switched to your current area . KING One Pro has been moved . If KING One Pro has been moved, initiate a new scan . Channel Signal Loss - 004 KING One Pro has not tracked to the...
Page 24
Symptom/Message Possible Cause Troubleshooting All Satellites Not Found - 150 Obstructions to the KING One Pro’s Make sure nothing is blocking the KING One view of the southern sky, such as Pro’s view of the southern sky, such as tree tree branches, severe rain, etc .
Symptom/Message Possible Cause Troubleshooting Unable to Access Feature - Feature not downloadable . Keep receiver in standby for 1 hour . Sporting Event Blackout - Blackout patterns are applied based on the physical address on your account . Events outside the area surrounding your physical address may not be available .
This warranty does not cover installation and external wiring, or remanufactured units . This warranty does not cover damage caused by the use of an accessory other than a KING accessory designed for the product . This warranty is not transferable from the original owner .
FCC GUIDELINES This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules . These limits are designed to provide reasonable protection against harmful interference in a residential installation . This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications .