Installation Materials Supplied By Installer; Antenna Unit Assembly; Unpack And Verify Components - KING PHOENIX KPD1000 Owner's Manual

automatic roof-mounted satellite TV antenna system!
• Please read this Owner's Manual thoroughly before installing and using the KING Phoenix .
• Keep this Owner's Manual and the included Quick Reference Guide in a safe place for future
reference .
• Follow all instructions and warnings . Set up and operate the KING Phoenix in accordance with
the instructions .
The installer is responsible for determining the most appropriate fasteners to secure the antenna unit to
the roof . Depending on the roof material, fasteners such as lag screws, well nuts, sheet metal screws,
!
toggle bolts and T anchors may be used, and should always be used with a roof-compatible sealant .
IMPORTANT! The installer is responsible for weatherproofing all holes with sealant.
• Drill and drill bit set (You will need a bit to drill a 1 inch hole in the roof for cable entry, and
any necessary bits for your choice of roof fasteners) .
• #2 Phillips screwdriver
• #3 Phillips screwdriver
• Wire cutters
• Pliers (for crimping Scotch-Lok connectors)
• Roof-compatible sealant
• Dielectric grease
• Appropriate tools and fasteners to install all components and wiring
1 . The KING Phoenix was shipped in two boxes . Open the boxes and verify all parts are present .
• Base mount assembly
• Power supply, 12VDC, 7 amp
• Control cable (30')
• Coax cable (35')
• Owner's manual
• Quick reference guide
• Reflector dish
• Controller
Page 2
Thank you for choosing the KING Phoenix
! Do not power wash the KING Phoenix.

INSTALLATION MATERIALS SUPPLIED BY INSTALLER

ANTENNA UNIT ASSEMBLY

UNPACK AND VERIFY COMPONENTS

BOX 2 (Box will be labeled for DISH or DIRECTV)
BOX 1
• Junction box
• Stow plate
• Clam shell
• Assembly and installation hardware
• Scotch-Lok connectors (2)
• Arm assembly with (2) stow brackets
• LNB