Page 1
KOP4800 Owner’s Manual Bell TV™ For use with satellite programming IMPORTANT! The KING One Pro works with DIRECTV , DISH , and Bell TV. This manual is for Bell TV ® ® subscribers. Manuals for DISH and DIRECTV subscribers are available at kingconnect.com.
IMPORTANT! The satellite TV market is expanding and changing. The information in this manual was accurate at the time of printing. If your KING One Pro Satellite Antenna does not operate as outlined in this manual, please call KING at (952) 345-8147 or visit our website at kingconnect.com. KING is not responsible for changes outside ®...
KING One Pro . 6 . Use caution when carrying the KING One Pro . Always carry the KING One Pro by the handle . 7 . Do not remove the cover of the KING One Pro without authorization . Doing so will void the limited warranty .
The KING One Pro requires an unobstructed view of the southern sky for the best signal reception . Be sure to place the KING One Pro in a location free from obstructions such as people, trees, build- ings, vehicles, etc . This will allow for the strongest signal and will help prevent any interruption to your programming .
SETUP CONTENTS Power Inserter Antenna Unit You will also need (sold separately): with Power Supply Bell Programming Subscription Cable(s) Bell Receiver KC1186 For the most up-to-date receiver compatibility information, go to kingconnect.com/support (3) Rubber Feet Quick Installation Registration Short Reference Guide Card 50’...
Power Supply MAIN Button Receivers sold separately 110 AC SAT IN To TV MAIN Receiver 50’ Coax Short KING Power Coax Inserter 110 AC SAT IN Optional AUX To TV Coax sold separately Receiver KC1187 After connecting and plugging in all components, wait for the power inserter LED to start flashing orange (about 10 seconds).
OPERATION ANTENNA CONFIGURATION The KING One Pro comes factory preset for mode 1. You will need to reconfigure the antenna for mode 3 (Bell TV) as shown on the next page . This is a one-time procedure unless you change services to DIRECTV or DISH .
Page 9
Make sure the LED is flashing orange (ready to scan) ORANGE ORANGE ORANGE To enter Configuration Mode, press and hold (~3 sec) the power inserter button until one of the KC1215 options below appears Press and release as needed to choose Mode 3 MODE 1 pattern repeats...
If you get a different color and/or flash pattern on the LED than steady green or one of the patterns shown on the next page, the LED is flashing an error code. Call KING Customer Service for an explanation of the problem.
Page 11
SATELLITES NOT FOUND MODE 3 (Bell TV) 82 not found pattern repeats... YELLOW GREEN 91 not found pattern repeats... YELLOW GREEN 82 & 91 not found continuous... KC1191 Page 9...
CHECK SWITCH TEST Run a check switch test . This is a one-time procedure unless noted in gray box below . NOTE: The SW21 switch is a receiver software configuration that is loaded into the receiver after successfully running a check switch test with the dish locked on and configured for the appropriate service. Step 5 is a one-time procedure that will not need to be repeated after successful installation, unless: a) check switch test is run again while the receiver is connected to a home dish system .
“SW21-3SAT” NO “X”s If the indicated results are not obtained, go back to Step 5 .1 and run test again . Contact KING if the check switch fails to load after 4 attempts . 5 .6 When the installation summary shows the successful check switch test results, save the settings, exit to the main menu screen and wait for programming to download .
SECOND RECEIVER OPERATION INITIAL SETUP FOR SECOND RECEIVER Antenna locked on receiver connected! 1 . With the antenna locked on the satellite and the second receiver connected to the antenna unit’s AUX port coax, use your receiver’s remote control and press MENU, 6, 1, 1 to display the Point Dish screen .
Page 15
DOWNLOADING PROGRAMMING TO THE SECOND RECEIVER 1 . After completing the steps on the previous page, reset the second receiver by pressing the POWER button on the front panel for 10 seconds . The TV picture will go away and should reappear within two minutes .
. Connect a known good coax directly from the antenna unit to the power inserter and see if the problem goes away . If it does, the vehicle’s wiring/coax is at fault . KING is not responsible for faulty vehicle wiring/coax .
KING One Pro almost anywhere for best line of sight to satellite . Keeps an- The KING One Pro is not compatible with tenna off the ground the MB100 Mounting Bracket . away from moisture . Use of the MB100 will void warranty .
This warranty does not cover installation and external wiring, or remanufactured units . This warranty does not cover damage caused by the use of an accessory other than a KING accessory designed for the product . This warranty is not transferable from the original owner .
FCC GUIDELINES This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules . These limits are designed to provide reasonable protection against harmful interference in a residential installation . This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications .