Page 1
KOP4800 Owner’s Manual ™ Bell For use with satellite programming The KING One Pro works with DIRECTV , DISH , and Bell TV. This manual is for ® ® Bell TV subscribers. Manuals for DIRECTV and DISH subscribers are available at kingconnect.com/support.
The satellite TV market is expanding and changing. The information in this manual was accurate at the time of printing. If your KING One Pro Satellite Antenna does not operate as outlined in this manual, please call KING at (952) 345-8147 or visit ®...
7. Do not remove the cover of the KING One Pro without authorization. Doing so will void the limited warranty. 8. Do not stack the KING One Pro on top of or below other electronic devices as this can cause heat build-up or block the satellite signal from reaching the KING One Pro.
CONNECT ANTENNA OBSERVE ALL PRECAUTIONS WHEN MAKING CONNECTIONS ON NEXT PAGE. Page 4...
Page 7
HAND-TIGHTEN COAX. OVER-TIGHTENING CAN DAMAGE CONNECTIONS. If your main receiver has two SAT IN ports: AUX coax may be connected to second SAT IN port for dual tuner usage. Make all connections and make sure your TV and receiver are turned on. During power up, the power inserter LED will pulsate orange for 10 seconds and BLUE ORANGE...
CONFIGURE ANTENNA The KING One Pro comes factory preset for MODE 1. Choose your desired MODE and follow the instructions on the next page. MODE 3: • Bell TV Service • Alarm disabled MODE 7: • Bell TV Service • Alarm enabled See page 13 for details on how the alarm works.
Page 11
2. Press and release button to choose desired setting. 3. When desired mode is displayed, press and hold button for about 3 seconds until the LED Go to the next page to start a scan. Time Out Function: If you do not press the button for one minute, the power inserter will go the LED will be saved.
SCAN FOR SATELLITES pattern repeats... TO THE SATELLITES IN THE SOUTHERN SKY AT ANY TIME! IF YOU MOVE THE ANTENNA ANY TIME DURING OR AFTER THE SCAN, YOU WILL HAVE TO REPEAT THE SCAN. When scan is complete and both satellites are found, the LED will turn steady green. Both satellites found (If you do not get steady green, see chart on opposite page.) BOTH SATELLITES FOUND: go to page 12 and run the check switch.
Page 13
PLEASE BE PATIENT! The antenna unit may lock onto the satellite in as little as 2 minutes, but may occasionally take up to 10-15 minutes. If no satellites are found, you will have to start a new scan. If you wish to start a new scan (for example the unit gets moved and you lose reception): press and release the power inserter button.
RUN CHECK SWITCH appropriate service. This is a one-time procedure that will not need to be repeated after successful installation, unless: a) check switch test is run again while the receiver is connected to a home dish system. b) check switch test is run when the receiver is not connected. 1.
“SW21-3SAT” NO “X”s If the indicated results are not obtained, go back to Step 1 and run test again. Contact KING if the check switch fails to load after 4 attempts. 6. When the installation summary shows the successful check switch test results, save the settings, exit to the main menu screen and wait for programming to download.
SECOND RECEIVER OPERATION INITIAL SETUP FOR SECOND RECEIVER Antenna locked on and receiver connected! 1. With the antenna locked on the satellite and the second receiver connected to the antenna unit’s AUX port coax, use your receiver’s remote control and press MENU, 6, 1, 1 to display the Point Dish screen.
Page 17
DOWNLOADING PROGRAMMING TO THE SECOND RECEIVER 1. After completing the steps on the previous page, reset the second receiver by pressing the POWER button on the front panel for 10 seconds. The TV picture will go away and should reappear within two minutes. The receiver will then download the program guide to show only the channels available on the current satellite as determined by the channel selected on the main receiver.
Connect a known good coax directly from the antenna unit to the power inserter and see if the problem goes away. If it does, the vehicle’s wiring/coax is at fault. KING is not responsible for faulty vehicle wiring/coax.
Allows you to position your KING One Pro almost anywhere for best line-of- sight to satellite. Keeps The KING One Pro is not compatible with away from moisture. the MB100 Mounting Bracket. Use of the MB100 will void warranty. KING Antenna not included.
This warranty does not cover installation and external wiring, or remanufactured units. This warranty does not cover damage caused by the use of an accessory other than a KING accessory designed for the product. This warranty is not transferable from the original owner.
FCC GUIDELINES This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.