KING PHOENIX KPD1000 Owner's Manual page 13

For Wally receivers: The DISH DPH LNB will only work with a single Wally .
110 VAC 110 VAC
12 VDC 12 VDC
CONTROL CABLE CONNECTION CONTROL CABLE CONNECTION
KC1392 KC1392
Double check all electrical and coax connections BEFORE connecting
satellite receiver and applying power.
The control cable has 12 wires that control motors and provide information
!
and sensor feedback. If the control cable is mis-wired it can cause damage
to the GPS and sensors, which may result in component failure.
Most problems are the result of incorrect connections or configurations.
DISH DPH LNB
Coax must run Coax must run
directly to Controller directly to Controller
To LNB To LNB
To REC To REC
WALLY rec WALLY rec
Page 13