Page 1
IMPORTANT! The KING One Pro works with DIRECTV, DISH, and Bell TV. This manual is for DIRECTV subscribers. Manuals for DISH and Bell subscribers are available at kingconnect.com. Do not use this manual if you are a DISH or Bell subscriber.
IMPORTANT! The satellite TV market is expanding and changing. The information in this manual was accurate at the time of printing. If your KING One Pro Satellite Antenna does not operate as outlined in this manual, please call KING at (952) 345-8147 or visit our website at kingconnect.com. KING is not responsible for changes outside ®...
7. Do not remove the cover of the KING One Pro without authorization. Doing so will void the limited warranty. 8. Do not stack the KING One Pro on top of or below other electronic devices as this can cause heat build-up or block the satellite signal from reaching the KING One Pro.
The KING One Pro requires an unobstructed view of the southern sky for the best signal reception. Be sure to place the KING One Pro in a location free from obstructions such as people, trees, buildings, vehicles, etc. This will allow for the strongest signal and will help prevent any interruption to your programming.
SETUP CONTENTS Power Inserter Antenna Unit You will also need (sold separately): with Power Supply DIRECTV Programming Subscription Cable(s) DIRECTV Receiver KC1193 For the most up-to-date receiver compatibility information, go to kingconnect.com/support (3) Rubber Quick Installation Feet Short Reference Registration Guide 50’...
CONNECTIONS NOTE: If you wish to roof mount the antenna, see the Installation Guide that came with your KING One Pro. Make the connections on page 6 or page 7. PAGE 6: Make these connections unless you have an H/HR25 or higher receiver.
HAND-TIGHTEN COAX. OVER-TIGHTENING CAN DAMAGE CONNECTIONS. 110 AC/DC Power Supply MAIN Receivers sold separately 110 AC 50’ RG-6 Coax Short Coax KING Power Inserter SAT IN POWER INSERTER FOR MAIN Receiver INDOOR USE ONLY. 110 AC Coax sold separately SAT IN...
Satellite 2 input. With SWM, only connect to the Satellite 1 port (labeled FTM or SWM) To SWM Receivers KING Antenna, KING Power Inserter (with power supply), 50’ coax and short coax included. All other items sold separately. KC1194...
Make this one-time setting in the receiver’s satellite setup menu. ANTENNA CONFIGURATION DIRECTV uses mode 1. The KING One Pro comes factory preset for mode 1. If your antenna is new, you will not need to configure it. IF YOUR ANTENNA IS NEW, SKIP THIS STEP AND GO TO PAGE 10.
Page 11
IF YOUR ANTENNA IS NEW, SKIP THIS STEP AND GO TO PAGE 10. Make sure the LED is flashing orange (ready to scan) ORANGE ORANGE ORANGE To enter Configuration Mode, press and hold (~3 sec) the power inserter button until one of the KC1217 options below appears Press and release as needed to...
If you get a different color and/or flash pattern on the LED than steady green or one of the patterns shown on the next page, the LED is flashing an error code. Call KING Customer Service for an explanation of the problem.
Page 13
SATELLITES NOT FOUND MODE 1 (DIRECTV) 101 not found pattern repeats... YELLOW GREEN 119 not found pattern repeats... YELLOW GREEN 101 & 119 not found continuous... KC1198 Page 11...
Connect a known good coax directly from the antenna unit to the power inserter and see if the problem goes away. If it does, the vehicle’s wiring/coax is at fault. KING is not responsible for faulty vehicle wiring/coax.
KING One Pro almost anywhere for best line of sight to satellite. Keeps an- The KING One Pro is not compatible with tenna off the ground the MB100 Mounting Bracket. away from moisture. Use of the MB100 will void warranty.
OEM manufacturer and 2) the dealer/installer receives prior authorization to perform the repair. A certified dealer must not perform any repair without first contacting KING for a Service Order Number. KING will advise the dealer on how to proceed with any repairs .
FCC GUIDELINES This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.