Raise Arm For Dish Installation - KING PHOENIX KPD1000 Owner's Manual

TIP
1 . Place the base mount on a stable and level work surface .
2 . Make connections as shown below .
12 VDC 12 VDC
CONTROL CABLE CONNECTION CONTROL CABLE CONNECTION
110 VAC 110 VAC
Included Power Supply Included Power Supply
3 . Raise the dish arm to the position shown above as follows:
A . Press POWER to turn on controller .
B . Press POWER again to enter menu .
C . Use up arrow button to go to menu item 3: MOVE ELEVATION .
D . Press POWER to select item 3 .
E . Press and hold up arrow to raise dish arm to position shown .
F . Press and hold POWER to turn off controller. Disconnect components.
SEARCH SEARCH
C
You can do the assembly steps on pages 3-6 on the ground or on the roof .
You may find it easier to take the components up to the roof before assembly.
RAISE DISH ARM TO INSTALL DISH ASSEMBLY
Back of Controller Back of Controller
Controller Cable Controller Cable
Satellite Antenna Controller Satellite Antenna Controller
STOW STOW
E
To REC To REC To LNB To LNB
KC1421 KC1421
Base Mount Base Mount
LNB LNB
POWER POWER
FLASH FLASH
PS PS
SELECT SELECT
KC1404 KC1404
A B D F
Page 3