Related Manuals for KING JACK OA8201
Summary of Contents for KING JACK OA8201
-
Page 1: Troubleshooting Guide
TROUBLESHOOTING GUIDE Digital HDTV Over-the-Air Antennas 11200 Hampshire Avenue South, Bloomington, MN 55438 PH 952.922.6889 || FAX 952.922.8424 || kingconnect.com... -
Page 3: Table Of Contents
REPLACE KING JACK ASSEMBLY........ -
Page 4: Introduction
The KING Service Department stays up to date with the latest information to assist you in keeping troubleshooting and repair time to a minimum. When calling our service department, a KING technician will issue a Customer ID Number (or Case Number) and then clearly define the proper course of action to follow. -
Page 5: Warranty Information
WARRANTY INFORMATION Section 2 KING Jack Antennas are covered by a TWO YEAR PARTS AND ONE YEAR LABOR limited warranty from the date of original purchase. This warranty does not cover installation and external wiring, or refurbished units. This warranty also does not apply where: •... -
Page 6: King Jack Operation With Surelock Signal Meter
1. Turn on Power Injector (power is now supplied to the KING Jack antenna). (Make sure TV is also on.) 2. Turn on KING SureLock Signal Meter with switch on side of rotational knob enclosure. 3. Rotate attenuator dial fully clockwise. -
Page 7: King Jack Operation Without Surelock Signal Meter
TV input. POSITIONING THE ANTENNA 1. Turn on Power Injector (power is now supplied to the KING Jack antenna). (Make sure TV is also on.) NOTE: In steps 2-5, keep track of in which direction you received the most channels when each scan is complete. -
Page 8: Troubleshooting Flowchart Reference Diagrams
TROUBLESHOOTING FLOWCHART REFERENCE DIAGRAMS Section 5 Page 6... - Page 9 Page 7...
-
Page 10: Troubleshooting Flowchart
TROUBLESHOOTING FLOWCHART Section 6 Page 8... - Page 11 Page 9...
-
Page 12: Block Times
BLOCK TIMES Section 7 REPLACEMENT PROCEDURE TIME IN MINUTES Power Injector Signal Meter Antenna Head KING JACK Assembly NOTE: See sections 9-12 for detailed instructions. Page 10... -
Page 13: Replacement Parts List
Coax, splitter to signal meter (metered KING Jack) 21038 Splitter (metered KING Jack) 21045 Coax w/F-connector, coach coax to antenna head (non-metered KING Jack) NOTE: Power injector part numbers vary and are marked on back of power injector. Page 11... -
Page 14: Replace Power Injector
REPLACE POWER INJECTOR Section 9 NOTE: Make sure power to power injector is turned off before proceeding. Page 12... -
Page 15: Replace Signal Meter
REPLACE SIGNAL METER Section 10 NOTE: Turn off power injector before proceeding. Page 13... -
Page 16: Replace Antenna Head
REPLACE ANTENNA HEAD Section 11 NOTE: Turn off power injector before proceeding. Page 14... - Page 17 Page 15...
-
Page 18: Replace King Jack Assembly
REPLACE KING JACK ASSEMBLY Section 12 NOTE: Turn off power injector before proceeding. Page 16... - Page 19 Page 17...
-
Page 20: Warranty Consideration Form
Page 18... - Page 21 NOTES: Page 19...
- Page 22 NOTES: Page 20...
- Page 24 ™ Simply better, by design. 11200 Hampshire Avenue South, Bloomington, MN 55438 PH 952.922.6889 || FAX 952.922.8424 || kingconnect.com © 2016 KING 22412 Rev A, KING Jack Antenna Troubleshooting Guide...