Table of Contents
Advertisement
Manual
00809-0500-4880
7. With one wrench holding the eductor elbow (N,
8. Slide the band heater (M) and heater insulator (K) from the sensor holder (J).
Remove eductor
Prerequisites
Remove the O
(Figure
Procedure
1. Use a straightedge to matchmark alignment of the eductor flat and elbow,
Rosemount OCX8800A
wrench on flats of sensor holder (J), unthread and remove the COe sensor
assembly (I).
Do not allow the eductor elbow to turn.
cell and heater strut assembly
2
10-10) before you start this procedure.
as shown in
Figure
10-12.
Maintenance and service
December 2022
Figure
10-10) and one
(Figure
10-8) and the COe assembly
257
Advertisement
Table of Contents
