Table of Contents
Advertisement
Manual
00809-0500-4880
7. If used, disconnect and remove the external relay leads from the alarm
8. Disconnect the signal cable leads from the O
Rosemount OCX8800A
output relay terminal block.
connector (J4) and from the COe and CJC connector (J5),
Figure 10-6: Remote Electronics Housing Cable Connections
A. Heater power connector (J3)
B. To ground screw
C. COe sensor and CJC connector (J4)
D. Electronics housing
E. O
cell and thermocouple connector (J5)
2
F. Signal cable
G. Heater power cable
Note
Wire colors shown are for cables supplied by Emerson.
Maintenance and service
December 2022
cell and thermocouple
2
Figure
10-6.
247
Advertisement
Table of Contents
