Toro Greensmaster eFlex 1800 Diagnostic Manual page 99

1. Main wire harness P02 connector
2. Main wire harness P01 connector
Pass Circuit continuity tested good at the listed locations. Go to Step 6.5 and follow the steps listed.
Fail For those items that failed, repair or replace the worn or damaged parts as required. Go to
Returning the Equipment to Service (page 19)
Step 6.5: Verify that no short conditions exist between the following pairs
of locations:
Location
1
2
Pass No shorts are identified at the listed locations. Go to
(page 19)
Fail For those items that failed, repair or replace the worn or damaged parts as required. Go to
Returning the Equipment to Service (page 19)
Note: Do not replace the battery pack unless the fault repeats.
P01 Main Harness TEC–2401 Connector Pin Identification
Harness Connector
Main P01
Figure 85
Main P02
Figure 85
and follow the steps listed.
Figure 85
3. TEC-2401 controller
and follow the steps listed.
Pin
1
7 or 8
F
E
D
Returning the Equipment to Service
and follow the steps listed.
99
Connector Graphic
1 12
6 7
A
C
B