Toro Greensmaster eFlex 1800 Diagnostic Manual page 68

Note: The wire harness diagram uses P01 and P02 for referencing these connectors, while the electrical
schematic uses P1 and P2.
Pass The continuity readings are good. Replace the TEC-2401. Go to Step 5.7.
Fail The continuity readings are not good. Repair or replace worn or damaged parts as required.
Go to Returning the Equipment to Service (page 19)
Step 5.7: Connect 4 devices and both terminators.
Refer to Figure 62.
•
InfoCenter: Connect the main wire harness P17 connector.
•
Main wire harness CAN terminator: Connect the terminator to the main wire harness P14 connector.
•
Battery pack: Connect the main wire harness P34 connector to the battery wire wire harness P34 connector.
•
Battery wire harness CAN terminator: Connect the terminator to the battery wire harness P03 connector.
•
TEC-2401: Connect the main wire harness P01 connector.
•
Motor: Connect the main wire harness P41 connector.
Go to Returning the Equipment to Service (page 19)
and follow the steps listed.
and follow the steps listed.
68