Toro Greensmaster eFlex 1800 Diagnostic Manual page 59

2. Measure the resistance between pins A and B of the main wire harness CAN terminator. The reading should be
108 to 132 ohms.
3. Check for continuity between the following pairs of locations:
Location
1
2
1
2
Pass
The continuity readings are good at the listed locations. Connect the main wire harness
CAN terminator to the main wire harness P14 connector. Go to Step 4.2.
Fail The continuity readings are not good. Repair or replace worn or damaged parts as
required. Go to
Step 4.2: Test the battery wire harness CAN terminator and wiring.
1. Disconnect the CAN terminator from the battery wire harness P03 connector
2. Measure the resistance between pins A and B of the battery wire harness CAN terminator. The reading should be
108 to 132 ohms.
B
Figure 60
CAN Terminator Pin Identification
Harness Connector
Main P37
Figure 58
Main P14
Figure 59
Main P37
Figure 58
Main P14
Figure 59
Returning the Equipment to Service (page 19)
Figure 61
Battery Harness P03 Connector Pin Identification
A
Pin
A
A
B
B
59
Connector Graphic
A B
C
and follow the steps listed.
(Figure 61).