Toro Greensmaster eFlex 1800 Diagnostic Manual page 92

Pin Identification
POS
P1
P2
S1
S2
NEG
3. Use dry compressed air (maximum 20 psi/137 kPa) to remove any debris or moisture from the battery wire harness P04
connector (Figure 82) and the battery adapter wire harness T-handle P04 connector that plugs into it.
WARNING
Compressed air is extremely forceful and can dislodge dirt and dust particles that can enter your
eyes or be inhaled.
•
Wear safety glasses to protect your eyes from airborne debris.
•
Wear a dust mask to avoid inhaling dirt and dust particles.
Note: Ensure the cavity plugs in the battery adapter harness P04 connector
compressed air cleaning process.
4. Connect the battery pack. Refer to
Pass The fault did not repeat. Go to
steps listed.
Fail The fault repeated. Go to step 5.
Step 5: Remove 2 access covers to aid troubleshooting.
Performing these steps provides access to connectors on the wire harnesses.
1. Remove the console cover. Refer to
2. Remove the power center cover. Refer to
Battery Adapter Harness P04 and P26 Connector Pin Identification
Battery Adapter Harness P04 Connector
Connecting the Battery Pack (page
Returning the Equipment to Service (page 19)
Console Cover (page
Power Center Cover (page
Figure 82
Description
42 to 64 Vdc Power
Not used (GT150 cavity plug)
Not used (GT150 cavity plug)
Not used (GT150 cavity plug)
Not used (GT150 cavity plug)
Ground
17).
19).
20).
92
Wire Color
Not used
Not used
Not used
Not used
Black (BK)
(Figure 82) are not removed during the
and follow the
Red (R)