Toro Greensmaster eFlex 1800 Diagnostic Manual page 71

Pass The fault did not repeat. Go to
steps listed.
Fail The fault repeated. Go to step 4.
Step 4: Check that the machine assemblies rotate freely and operate without
excessive force and friction.
For free rotation checks, refer to the eFlex Service Manual for disengaging the drum and reel drive/clutch.
1. Check that the housings and covers are properly installed.
2. Check that the brake assembly is properly installed and adjusted.
3. Check for any reel-to-bedknife contact.
4. Remove the motor and ensure that it turns freely by hand.
5. Check for damage, wear, and proper adjustment of the traction assembly, transmission assembly, and reel assembly.
Pass The fault did not repeat. Go to
steps listed.
Fail The fault repeated. Go to step 5.
Step 5: Remove 2 access covers to aid troubleshooting.
Performing these steps provides access to connectors on the wire harnesses.
1. Remove the console cover. Refer to
2. Remove the power center cover. Refer to
Step 6: Use a multimeter to check for ground to the motor.
Note: You will find additional wire harness and connector information in
Appendix B: Toro Electronic Controller Connections (page
Note: Inspect the wire harness for damage and wear while checking the items in the following steps. Refer to
Wire Harnesses and Component Connector Assemblies (page
1. Disconnect the battery wire harness P01 connector. Refer to
(page 8).
2. Check for continuity between the following pairs of locations:
Location Harness
1 Main
Figure 68
2 Main
Figure 69
Returning the Equipment to Service (page 19)
Returning the Equipment to Service (page 19)
Console Cover (page
Power Center Cover (page
135).
Pin
Connector
P42 2
P26 B
19).
20).
Appendix A: Wire Harnesses (page 113)
13).
Raise the Battery Pack and Disconnect the P01 Connector
Connector Graphic
71
and follow the
and follow the
and
Inspecting the
1
2
A
B