Toro Greensmaster eFlex 1800 Diagnostic Manual page 96

Pin Identification
*P2
*S1
*S2
NEG
Note: *Logic pins are used only during charging on the battery pack charger.
Pin Identification
A
B
C
D
E
F
Pass Circuit continuity tested good at the listed locations. Go to Step 6.3 and follow the steps listed.
Fail For those items that failed, repair or replace the worn or damaged parts as required. Go to
Returning the Equipment to Service (page 19)
Step 6.3: Verify that no short conditions exist between the following battery
wire harness connectors:
Location Harness
1 Battery
Figure 83
2 Battery
Figure 83
1 Battery
Figure 83
Battery Harness P04 Connector (cont'd.)
Description
CAN – (Low)
Battery Pack Wake Up
Not used
Ground
Battery Harness P34 Connector
Description
Battery Pack Wake up
Not used
Not used
CAN + (High)
Not used
CAN – (Low)
Connector Pin
P01 4
P01 5
P01 4
96
Black/White (BK/W)
Black/White (BK/W)
and follow the steps listed.
Connector Graphic
1
2
1
2
Wire Color
Blue (BU)
Not used
Black (BK)
Wire Color
Blue (BU)
Not used
Not used
Red/White (R/W)
Not used
3
5
6
4
3
5
6
4