Main Harness P06 Connector and EZ-Turn (Slow-in-Turn) Switch Pin Identification
Pass
Fail
Electrical Diagram
The TEC-2401 P01 connector, pin 5, provides 12 Vdc to the InfoCenter through the main wire harness P17 connector,
pin 2. The TEC-2401 P02 connector, pin 7, provides harness ground to the InfoCenter through the main wire harness
P17 connector, pin 1.
Circuit continuity tested good and no shorts are identified at the listed locations. Go to
Returning the Equipment to Service (page 19)
For those items that failed, repair or replace worn or damaged parts as required. Go
to
Returning the Equipment to Service (page 19)
Hour Meter (optional)
Figure 37
and follow the steps listed.
Figure 38
InfoCenter
Figure 39
33
and follow the steps listed.