Toro Greensmaster eFlex 1800 Diagnostic Manual page 65

Pass The continuity readings are good. Replace the motor. Go to
Service (page 19)
Fail The continuity readings are not good. Repair or replace worn or damaged parts as required.
Go to Returning the Equipment to Service (page 19)
Step 5.5: Test the battery pack and associated wiring.
1. Connect the main wire harness P34 connector to the battery wire harness P34 connector
2. Use a multimeter to measure the resistance between the main wire harness P37 connector, pins A and B
58). The reading should be 2.2 k to 2.7 k ohms (2200 to 2700).
Pass The reading is good. Disconnect connector P34 and go to Step 5.6.
Fail The reading is not good. Go to Step 5.5.1.
Step 5.5.1: Test the battery pack wiring.
1. Disconnect the battery wire harness P01 connector. Refer to
the P01 Connector (page
2. Check for continuity between the following pairs of locations:
Location
1
2
1
2
and follow the steps listed.
8).
Harness Connector
Battery P34
Figure 65
Battery P01
Figure 65
Battery P34
Figure 65
Battery P01
Figure 65
and follow the steps listed.
Raise the Battery Pack and Disconnect
Pin
D
1
1
2
F
2 1
2
65
Returning the Equipment to
(Figure 62).
Connector Graphic
C B A
D
F
E
3
5
6
4
C B A
D F
E
3
5
6
4
(Figure