Toro Greensmaster eFlex 1800 Diagnostic Manual page 27

Main Harness P23 Connector and EZ-Turn (Slow-in-Turn) Sensor Pin Identification
Pass 12 Vdc measured good at the listed location. Go to step 4.4.
Fail 12 Vdc did not measure good at the listed location. Repair or replace worn or
damaged parts as required. Go to
follow the steps listed.
Step 4.4: Check the wire harness for continuity and verify that there are
no short conditions.
Note: Inspect the main wire harness while checking the items in the following steps. Refer to
Harnesses and Component Connector Assemblies (page
Note: Troubleshoot 1 circuit or component at a time. Disconnect or isolate each component or wire harness section
from the system before testing.
Disconnect the battery pack. Refer to
Step 4.4.1: Check the wire harness for continuity and verify that there
are no short conditions for the InfoCenter.
1. Check for continuity between the following pairs of locations:
Location
1
2
Figure 32
13).
Disconnecting the Battery Pack (page
Harness Connector
Main P01
Figure 33
Main P17
Figure 34
27
Returning the Equipment to Service (page 19)
17).
Pin Connector Graphic
5
1
6
2
Inspecting the Wire
12
7
4 3
6
1
and