Ethernet Setup - Johnson Controls FRICK QUANTUM HD Setup

Compressor control panel communications setup
Hide thumbs Also See for FRICK QUANTUM HD:
Table of Contents

Advertisement

090.040-CS (JAN 14)
Page 10
** UTP = Unshielded Twisted Pair

ETHERNET SETUP

ACCESSING:
ernet connection:
DESCRIPTION: This screen is used to view and set basic Eth-
ernet values.
IP ADDRESS
The following fields are provided:
[IP Address] - The network administrator will
enter the numerical IP address for this specific
Quantum™ HD panel. This setpoint box will be
automatically assigned if the address type is set
to DHCP.
[Gateway Address] - The network or LAN ad-
ministrator will enter the numerical Gateway ad-
dress. This setpoint box will be automatically as-
signed if the address type is set to DHCP.
[Subnet Mask] – Like IP addresses, a subnet
mask contains four bytes (32 bits) and is often
written using the same "dotted-decimal" nota-
tion. Subnet masks accompany an IP address and
the two values work together. This setpoint box
will be automatically assigned if the address type
is set to DHCP. Applying the subnet mask to an IP
address splits the address into two parts, an ex-
tended network address and a host address. For
a subnet mask to be valid, its leftmost bits must
QUANTUM™ HD COMPRESSOR CONTROL PANEL
COMMUNICATIONS SETUP
CONFIGURATION
Communications - Ethernet
Communications
Once all of the cabling has been run and all connections
have been made, the next step is to setup the Quantum™
HD software for connecting the panel to an existing Eth-
Ethernet
be set to '1'. The rightmost bits in a valid subnet
mask must be set to '0', not '1'. All valid subnet
masks contain two parts: the left side with all
mask bits set to '1' (the extended network por-
tion) and the right side with all bits set to '0' (the
host portion).
[Web Server Port] - The network administra-
tor will enter the numerical address for this Web
port (80 is typical).
[Submit Changes] - Select this button after
changes have been made to the above settings
to submit them to the control program.
ETHERNET
The following fields are provided (depending upon
which protocol is needed):
[ModBus TCP]
Disabled
Enabled
[Ethernet/IP]
Disabled

Advertisement

Table of Contents
loading

Table of Contents