Replacing The Power Supply Assembly - GE MAC 1600 Service Manual

Maintenance
4. Carefully note the orientation and position of the modem you are about to
remove.
This information is needed when inserting the replacement modem.
5. Using a small, flat blade screwdriver, gently lift each end of the modem to
release its pins from their sockets.
6. Using your fingers, lift the modem and remove it from the device.
7. Reassemble the internal modem by reversing the steps for removal.
a.
b.
c.
d.
8. Perform the applicable checkout procedures.
Refer to

Replacing the Power Supply Assembly

1. Disconnect the system from AC power.
2. Remove the paper tray as described in
on page
3. Remove the battery as described in
72
Use the figure in step 4
modem in the hole.
Visually align the pins on the modem with the sockets on the mainboard.
Push the modem to seat it in the sockets.
If the gaps between the modem and the hole do not match the figure
in step 4, remove the modem and repeat this step until the modem is
properly seated as shown in step 4.
"Functional Checkout" on page
64.
MAC™ 1600
of this procedure to orient and position the
99.
"Replacing the Paper Tray Assembly"
"Replacing the Battery" on page 64.
2028451-183E