GE MAC 1600 Service Manual page 83

Replacing the Printer Assembly
Use this procedure to replace the printer assembly.
1. While holding the replacement printer assembly as shown in the following
illustration, route the ribbon cable (1) between the printer board and the
printhead.
2. Lower the printer assembly in position.
Place the printer motor connector into its guide rails while routing the four wires
in the channel (1) as shown in the following illustration. If these wires are not
properly routed in the channel, they will be pinched upon reassembly.
3. Slide the printer assembly to its final mounting position.
2028451-183E MAC™ 1600
Maintenance
83