Smartgen HGM6000K Series Operating Manual page 18

Num Parameter
P 18 Fail to stop
(P13) delay
P 19 ATS close
(P14) time
P 20
Flywheel teeth (10-300)
(P15)
Gens
P 21
abnormal
(P16)
delay
P 22 Gens over volt
(P17) shutdown
Gens under
P 23
volt
(P18)
shutdown
P 24 Under speed
(P19) shutdown
HGM6000K Series Automatic Generator Module
HGM6000K Series Automatic Generator Module
Range
(0-120)s
(0-10)s
(0-20.0)s
(30-360)V
(30-360)V
(0-6000)RPM
Default
When
shutdown output time" for
zero, idle time delay stop
steady to time, and when
0 "ETS solenoid hold output
time" is not equal to zero,
from
shutdown delay end to stop
steady need of time.
Mains or Genset switch
closing pulse width, when it
5.0
is
continuous.
The
engine starter teeth, used
for
118 condition
engine speed detection, see
behind
instructions.
Too high or too low voltage
10.0
genset alarm delay.
When genset voltage is
over than the point, genset
over shutdown voltage is
264
active. When the point is
360V, genset over voltage is
disabled.
When genset voltage is
under than the point, genset
under shutdown voltage is
196
active. When the point is
30V, genset under voltage
is disabled.
When the engine speed is
under than the point and
1200 hold great than 10 seconds,
genset
speed is active.
ISSUE 2011-06-20 Version 1.7
Remark
"ETS solenoid
ETS solenoid
zero, output
flywheel teeth
starters separation
judgment and
the installation
under shutdown
Page 19 of 34
is
on