To Upgrade The Sun Storedge 6130 Array Management Software - Sun Microsystems StorageTek 5320 Getting Started Manual

▼
To Upgrade the Sun StorEdge 6130 Array Management
Software
1. From the Sun StorEdge 6130 array management interface, log in to the Sun Storage
Automated Diagnostic Environment and clear all existing alarms.
2. Log in to the management host as root.
3. Download the latest Sun StorEdge 6130 host software package v1.3 for Solaris OS
from http://sunsolve.sun.com to any working directory on the management
host.
4. Unzip the distribution file and untar the file.
5. Enter the following command:
./upgrade -n
The -n option specifies a non-interactive upgrade. After asking whether you want to
upgrade software or firmware, the script completes the upgrade without pausing for
questions
When the installation is complete, a confirmation is displayed followed by the date
and time that the upgrade finished.
You can now install the patches as described in the next section.
▼
To Upgrade the Sun StorEdge 6130 Array Firmware
1. Download the required patches (see
http://sunsolve.sun.com/.
2. Stop all I/O to the disk drives.
3. Log in to the management host as root.
4. Change to the directory to which you downloaded the software.
5. Install each patch by following the instructions in the patch README file.
6. Verify that the latest patches are installed:
a. Open a supported browser.
b. Enter the IP address of the management host using this format:
https://host_IP:6789
c. Log in to the management software.
d. Click Sun StorEdge 6130 Configuration Service.
The Array Summary page is displayed.
176 Sun StorageTek 5320 NAS Appliance and Gateway System Getting Started Guide • May 2006
.
) from
TABLE 5-2