Programming; Delta-Q - Taylor-Dunn B5-540-48XL Service And Replacement Parts Manual

B5-440-36 / B5-440-48 / B5-540-48XL / BF-030-48

PROGRAMMING

Delta-Q

NOTICE
The algorithms stored in the Delta-Q charger will vary depending on
where the charger was obtained. The following information applies ONLY
to chargers purchased from Taylor-Dunn.
Using the incorrect charging algorithm may result in loss of run time due
to insufficiently charged batteries or premature failure of the batteries
due to overcharging.
The Delta-Q charger has 10 pre-programed algorithms available.
Identify Active Profile
1: Disconnect AC power source and wait for LED's to turn off.
2: Remove the positive charger lead from the battery.
3: Reconnect to AC power source.
4: After the self test completes, the current algorithm code will be displayed on the charger LED's (see
illustration).
Codes 1 through 6 will show on the top LED's and also flash the lower LED.
Codes above 6 will flash the lower LED.
Codes with 2-digits will flash the lower LED in sequence. Each digit will be followed by a short pause. There
will be a long pause after the code is complete and then it will repeat.
The algorithm code will be displayed for 11 seconds.
The following is the list of algorithms available in Taylor-Dunn chargers. Contact Delta-Q for any additional detail or
for information on codes not listed.
Code Mfg
1 Trojan
7 Trojan
11 Generic
26 Deka
42 Discover
43 Discover
51 Exide/Sonnenschein 180Ah
71 Generic
125 Full River
151 Full River
MB-440-06
Battery Type Algorithm
Generic FLA
T145 FLA dV/dT
200-255Ah FLA dV/dT
8GGC2 GEL
80-150Ah AGM
Generic AGM
GEL
140-200Ah FLA dV/dT
160-220Ah AGM
220-290Ah AGM
Chargers
Page 93