Table of Contents
Advertisement
MX0109A and N2836A InfiniiMax III Solder-in Probe Heads
The following two solder-in probe heads are available for InfiniiMax III amplifiers.
•
•
These probe heads are economical semi-permanent connections that provide up to
26 GHz of system bandwidth.
Figure 30 MX0109A and N2836A InfiniiMax III solder-in probe heads
The following table highlights the key features of these probe heads.
Supports testing in extreme temperature ranges.
Can withstand –55°C to +150°C temperature range for up to 750
test cycles. Refer to the topic
with MX0109A Probe Head"
InfiniiMode capable. InfiniiMode allows you to make differential, common mode, and single ended measurements without
having to re-solder the tip leads. To use the InfiniiMode capability of these probe heads, use these with InfiniiMax III+ series
The span of leads can be adjusted from 5 mil - 250 mil (0.127 mm - 6.35 mm).
User replaceable resistor leads. To know how to install / repair resistor leads, refer to
MX0109A and N2836A have different S parameters stored in the oscilloscope's firmware. On selecting the probe head in the
oscilloscope's Select Probe Head dialog box, the appropriate S parameter file for the probe head is loaded. This file is used in
conjunction with the probe amplifier's S parameters to compute the overall probe correction for your measurement case.
InfiniiMax III Series Probes User's Guide
MX0109A Extreme Temperature Solder-in probe head
N2836A InfiniiMax III Solder-in probe head
MX0109A
MX0109A
"Extreme Temperature Testing
on page 43 to know more.
probe amplifiers.
The minimum required Infiniium software version for the MX0109A probe head is as
N OT E
follows:
- 10.10 or higher (for Infiniium UXR-Series oscilloscopes)
- 6.40 or higher (for all other compatible oscilloscopes)
Can withstand –40°C to +85°C temperature range.
page 56.
InfiniiMax III Probe Heads
N2836A
N2836A
"Replacing Axial Resistor Tips"
2
on
39
Advertisement
Table of Contents
