Table of Contents
Advertisement
Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
6.3.1 Set the Scene Tracking
Set the scene tracking function. The optical camera will track the target when the VCA rule is
triggered which is configured on the thermal camera.
Steps
1. Go to Configuration → VCA → Scene Configuration and configure the parameters.
Scene Ratio
It is the tracking ratio of the target in current scene. Select the channel No. and adjust it in
PTZ control panel. The scene ratio in optical channel and thermal channel can be set
independently.
Enable Track
Enable tracking the target in the scene.
Tracking Duration
Set the duration of tracking. If the value is selected as 0, the tracking duration will not be
limited.
Limited Tracking
You can set the limited position for the tracking.
Click Save.
2. Go to Configuration → VCA → Advanced Configuration, and set parameter.
Post-tracking
Set the duration of automatic tracking of the target after it stops.
3. Go to Configuration → VCA → Zooming Ratio and configure the parameters. The optical
camera will track the target when the VCA rule is triggered which is configured on the thermal
camera.
1) Set the appropriate tracking zooming ratio with the PTZ control panel.
2) Click Save.
4. Click Save.
6.3.2 Set Rules
The device can detect whether there is any target break the VCA rules. The optical camera will
track the target or the device will alarm when the VCA rule is triggered.
Steps
1. Go to Configuration → VCA → Rule.
2. Click
to add a new rule.
3. Enter the rule name, and click the drop down menu to select Rule Type.
22
Advertisement
Table of Contents
