HIKVISION DS-2TD8166-150ZH2F/V2 User Manual page 32

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
In FOV
Out FOV
Note
● Set vertexes clockwise or anticlockwise in sequence.
● The pan angle of set area should be from 2 to 80 degrees, and tilt angle should be from 1 to
45 degrees.
● Draw four vertexes again if you want to change the shielded area.
5. Check Display Shield Area to show the shield area on the live view.
6. Click Add to save the fire detection shield, and it will be listed in the Fire Source Detection
Shield List area; you can select a region and click Delete to delete it from the list; you can also
define the color of the regions.
7. Click Save.
Select this mode if the shielded area is in the current scene.
1. Click the PTZ control buttons to find the area you want to shield
from the fire detection.
2. Click Draw Area, and drag the mouse in the live view to draw the
area.
3. You can drag the corners of the red rectangle area to change its
shape and size.
4. Click Stop Drawing to finish drawing, or click Clear All to clear all
of the areas you set without saving them.
Select this mode if the shielded area exceeds the current scene.
1. Click Draw Area, and a red cursor displays in live view.
2. Select Vertex NO. 1, and adjust the live view image by clicking the
PTZ control buttons.
3. When one corner of the shielded area is on the red cursor, click
Set Vertex.
4. Repeat steps b-c to set other three vertexes.
5. Click Stop Drawing to finish drawing, or click Clear All to clear all
of the vertexes you set.
18