Table of Contents
Advertisement
Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
6. Check to enable Filter by Pixel. Then Draw max size and min size rectangles to filter the target
among human, vehicle, animal, and others. Only the target whose size is between the Max. Size
and Min. Size value will trigger the alarm.
Note
● You can draw the max size and min size rectangles according to the real target in the scene.
The recommended size is 1.2 times of the target.
● Due to the main difference between human and animal is the height. Just concern the height
of animal.
● Click
to copy the same settings to other rules.
7. Click Save.
8. Optional: you can shield certain areas from being detected. Refer to for detailed settings.
Note
Repeat steps above to configure multiply rules. Set the arming schedule and linkage method for
each rule.
9. Refer to Set Arming Schedule for setting scheduled time. Refer to Linkage Method Settings for
setting linkage method.
6.3.3 Set the Scene Patrol
The device support patrol tracking for multiple important scenes. The alarm will be triggered if the
rule is breaked during patrol sequence.
Steps
1. Set the scene patrol sequence.
Scene Name
Enter a custom scene name.
Duration
Set the dwell time of the scene when doing patrol tracking.
2. Click the up, down arrow to adjust the patrol sequence.
3. Click Save.
6.4 Advanced Configuration
Go to Configuration → VCA → Advanced Configurationand configure the parameters.
Detection Parameters
Detection Sensitivity
The higher the sensitivity is, the easier the target will be detected.
24
Advertisement
Table of Contents
