Parameter List - Fuji Electric Micro Control X Instruction Manual

6. Parameter List

and then re-start the controller.
Parameter
Name
1 Switchover between auto and manual
mode
2
3
Ramp soak control command
5
6
SV selection
9
10
11
12
13
15
16
19
20
21
22
23
Electric power calculation command
Key lock
Parameter
Name
50 Proportional band (%)
51 Integration time
52
53
55
56 Output convergence value (%)
59 SV limit (lower)
60 SV limit (upper)
61 OUT1 proportion cycle
62 OUT2 proportion cycle
63 OUT1 lower limit
OUT1 upper limit
65 OUT2 lower limit
66 OUT2 upper limit
Type of output limiter
Beta
Function
Switchover between auto and manual modes
Changes ramp soak run states
Runs auto-tuning.
Cancels the alarm output latch state
Sets the key lock to prevent wrong operation
Function
Setting ""0"" will turn off integration."
Setting ""0"" will turn off differentiation."
Shifts the cooling proportional band from the set value
Offset value which is added to the MV output value
Sets the range of integration control
"Selects single control or dual control. Sets the control action
(normal or reverse)."
Sets the lower limit of SV
Sets the upper limit of SV
"Sets the proportion cycle of the control output (OUT1)
(contacts, SSR drive)"
"Sets the proportion cycle of the control output (OUT2)
(contacts, SSR drive)"
Sets the lower limit of the control output(OUT1)
Sets the upper limit of the control output(OUT1)
Sets the lower limit of the control output(OUT2)
Sets the upper limit of the control output(OUT2)
Sets the type of output limiter
Setting range
Sv1
Sv2
Sv3
Sv5
Sv6
oFF (stop calculation)
rUn (run calculation)
oFF (no lock)
Setting range
0.1 to 999.9%
0 to 3200 sec
0.0 to 999.9 sec
0 to 50%FS
0.0 to 100.0
-50.0 to 50.0%
-100.0 to 100.0%
0 to 100%FS
0 to 100%FS
0 to 100%FS
1 to 150 sec
1 to 150 sec
-5.0 to 105.0%
-5.0 to 105.0%
-5.0 to 105.0%
-5.0 to 105.0%
0 to 15
-199.9to 300.0%
0.0 to 999.9%
oFF This parameter is not displayed in default setting. If you
need to change this parameter, change the setting of
"Ch11 dSP" so that it appears.
oFF
oFF
soak).
oFF
oFF
"When changing the SV with the front key, do not
change the "Svn" parameter via communication.
Otherwise, the changed SV may not be stored
correctly."
2.50%FS
2.50%FS
2.50%FS
2.50%FS
2.50%FS
oFF
oFF
5.0%
60.0 sec
0.25%FS
1.0
0.0%
100%FS
[RESET]
0.00%FS
100.00%FS
30 (relay)
2 (SSR)
1 (current)
30 (relay)
2 (SSR)
1 (current)
-5.0%
105.0%
-5.0%
105.0%
0
100.0%