Operation - Fuji Electric Micro Control X Instruction Manual

2. Caution
2-1. Cautions when Installing
Please avoid installing in the following locations.
(If the equipment gets wet, there is a risk of electric shock or fire, so have it inspected by Fuji
distributor.)
Recommended site conditions
establishment, such as residential areas, or it may cause radio interference. If you use this equipment in
domestic locations, take adequate measures on the outside of the equipment to reduce radio interference.
2-2. Cautions when Attaching to the Panels
tighten with a screwdriver.
and hence reduce the torque.
Cracking to the central area will not cause any problems in terms of usability of the equipment.
plastic.)
To effect waterproof, the included packing is shall be attached between the controller and the
panel according to the guidelines below. (Incorrect attachment may cause the equipment to lose its
waterproof capabilities.)
Fig. 1 Fig. 2
Unit
Front
Packing
Panel Panel
(Horizontal attachment)
Caution
unit.
2-3. Cautions for Wiring
with small lead wire resistance and without any resistance difference among the three wires.
load lines.
wire.
effectiveness will be decreased.
the more effective the connection is against noise.)
frequency is high, selecting a SSR drive output type is recommended.
[Proportionate cycles] Relay output: 30 seconds or more, SSR drive output:
1 second or more
power line for the heater and the controller.
as relay output equipment are connected, use of a surge absorber is
surges and to ensure long-term use.
Voltage
100 V
200 V
Fig. 3
Mounting fixture
Screw
Packing
Case
(Bad)
Screw
Mounting fixture
(Example)
always turn the power OFF.
2-5. Others
is necessary, use a neutral cleaning agent.
rmation of model code
1 Installation and Mounting
2 Wiring Connection
Turn Power On
3 Display and Operations
4 Parameter List
5 Functions of the Temperature Controller
Packing
Case
(Good)
6 Advanced Usage

Operation

7 Error Indications
Wait 30 minutes for the controller to stabilized thermally. Operations such as
Caution
measurements should be taken after the equipment has been on for 30 minutes
or more.
- 2 -
Please con rm that the model delivered matches your order.
External dimensions
Panel cut dimensions
Terminal connections dia ram
"4 Wir
value
"5 Display and Oper
Basic Operation Methods
"5 Display and Oper
Parameter List
Par
Input/Output/Control
r
A
rameters
Display dur