Parameter Setting Procedure - Fuji Electric PXG-9 Communication Instruction Manual

Parameter Setting Procedure

The following steps explain how to change the settings to station number "3", parity setting "9600bps/none", and communication
permissions "read and writable" as an example.
Press and hold the
1
The MV1 of the monitoring screen is displayed.
Press and hold the
2
menu
("o o o o P P P P E E E E C C C C h h h h 1 1 1 1 "), then use the
The communication menu is displayed.
(Note) If your micro controller does not have a communication function, "C C C C o o o o M M M M C C C C h h h h 9 9 9 9 " will not be displayed. Please check with your
model.
Press and hold the
3
"S S S S T T T T n n n n o o o o ."
The station number is displayed.
Press the key, then use the
4
number to "3" when the bottom part of the display begins to blink.
This sets the parameter to "3".
Press the key to confirm the setting.
5
keys to select the parity setting ("C C C C o o o o M M M M ").
Use the
6
Press the key, then use the
7
setting to "96no" when the bottom part of the display begins to
blink.
The parity setting is set to "9600 bps/none".
Press the key to confirm the setting.
8
Use the keys to select the communication permissions
9
("S S S S C C C C C C C C ").
Press the key, then use the
1 0
"rW" when the bottom part of the display begins to blink.
"read/write" is selected.
Press the key to confirm the setting.
1 1
key to display "M M M M v v v v 1 1 1 1 ".
key to display the setup mode operation
keys to display "C C C C o o o o M M M M C C C C h h h h 9 9 9 9 ".
key, the use the
keys to set station
keys to set the parity
keys to set the protocol to
– 17 –
keys to display
Chapter
4