Set Up The Power Demand Configuration; Set Up The En50160 Evaluation - Siemens ACCESS 9340 Reference Manual

ACCESS 9340 and 9360 Meters
Chapter 3—Operation

Set Up the Power Demand Configuration

###:
1. Press until DMD is visible.
2. Press DMD.
3. Select the demand configuration. Choices
are COMMS, RCOMM, CLOCK, RCLCK,
IENGY, THERM, SLIDE, BLOCK, RBLCK,
INPUT, and RINPUT.
4. Press OK.
5. Enter the INTVL (interval) and press OK.
6. Enter the SUB-I (sub-interval) and press
OK.
1;
7. Press until you are asked to save your
changes.
8. Press YES to save the changes.

Set Up the EN50160 Evaluation

###:
1. Press until 50160 is visible.
2. Press 50160.
3. Select ON.
4. Press OK.
5. Change the nominal voltage (NOM V)
value if desired (230 is the default).
6. Press OK to return to the SETUP MODE
screen.
1;
7. Press until you are prompted to save
your changes.
8. Press YES to save your changes and
reset the meter.
EN–30




© 2008 Siemens Energy & Automation, Inc. All Rights Reserved.
PMCM-9340D-0208





  




  
2/2008